KY-038 - Microphone Geräusch Detektor Modul

KY 038Einführung

Das Geräusch Detektor Modul verfügt über ein Microphon und hat zwei Ausgabemöglichkeiten:

  • AO, analoge Ausgabe des Geräuschpegels
  • DO, wenn die Geräuschintensität einen Schwellwert übersteigt wird das Signal auf D0 HIGH, ansonsten LOW

Der Schwellwert kann mit dem Potentiometer auf der Sensorplatine eingestellt werden

Anschlüsse

  • Pin + to Arduino 5+
  • Pin - to Arduino -
  • Pin A0 to Arduino A0 (for analog program)
  • Pin D0 to Arduino 13 (for digital program)
 

Beispielcode

 

1. Beispiel: Digital output

int Led = 13 ;// define LED Interface
int buttonpin = 3; // define D0 Sensor Interface
int val = 0;// define numeric variables val
 
void setup ()
{
  pinMode (Led, OUTPUT) ;// define LED as output interface
  pinMode (buttonpin, INPUT) ;// output interface D0 is defined sensor
}
 
void loop ()
{
  val = digitalRead(buttonpin);// digital interface will be assigned a value of pin 3 to read val
  if (val == HIGH) // When the sound detection module detects a signal, LED flashes
  {
    digitalWrite (Led, HIGH);
  }
  else
  {
    digitalWrite (Led, LOW);
  }
}

2. Beispiel: Analog output

int sensorPin = A0; // select the input pin for the potentiometer
int ledPin = 13; // select the pin for the LED
int sensorValue = 0; // variable to store the value coming from the sensor
 
void setup () 
{
  pinMode (ledPin, OUTPUT);
  Serial.begin (9600);
}
 
void loop () 
{
  sensorValue = analogRead (sensorPin);
  digitalWrite (ledPin, HIGH);
  delay (sensorValue);
  digitalWrite (ledPin, LOW);
  delay (sensorValue);
  Serial.println (sensorValue, DEC);
}